If you’re an Engineering student at RMIT University, you probably have come across the OUSB Board. This board is similar to an Arduino however it has a bunch of inputs and sensors and is powered by an Atmega32A. I found this board to be a great learning experience as I’ve done various projects and it was my first dive into embedded systems.
I’m writing this tutorial for those who want to flash their OUSB Board to how they got it originally. The reason for this is because I had different firmware running for a project but now I need to interface the “ousb” executable again. This tutorial will be for Linux but the steps should be similar in Windows or MacOS as well.
Assuming you’re on a Linux distribution, download and install
avrdude from your package manager. If you aren’t sure what this is, you probably have to do something like:
# Fedora - Or dnfdragora for GUI sudo dnf install avrdude # Ubuntu - You can use synaptic (GUI front-end) sudo apt install avrdude # Arch Linux / Manjaro - You can use Pamac/Octopi sudo pacman -S avrdude
You also want to download the OUSB firmware hex file from here. Simply right click on the link named
open_usb_io_firmwarehex and save it, making sure to remove the
.gif from the end of it and renaming it was
I’m not responsible for bricked boards. I’ve only tested this on one board so proceed at your own risk!
Plug your OUSB Board into your computer and make sure to enable programming mode. This is done by moving the jumper from the LED area and plugging it into the one near the potentiometer. Refer to the open-usb-io reference manual if you’re unsure.
Open up a terminal and type
lsusb and see if the device is recognised…
Navigate to the directory where your hex file is stored and run the following command. This command will write to the microcontroller overwriting any firmware that is stored on it with the one you just downloaded.
sudo avrdude -c USBasp -p atmega32 -U flash:w:open_usb_io_firmware.hex
You should get an output like this:
That’s it! Now you can remove the jumper and put it back to its original spot (normal functioning mode) run a command using the
ousb binary. You may have to run it as root as it needs permission to communicate to the device.
sudo ousb io portb 255
If it worked for you, let me know! Of course, if you’re on Windows you probably have to download avrdude and the USBasp driver separately and install them.